Lectric eBikes Hard Cooler

For Lectric eBikes products, we are no longer able to sell them online. They are only available for purchase in person at our warehouse.

 

It's hard to beat an ice-cold beverage at a tailgate, picnic, or get-together on a warm summer day. Keep it cool with the Lectric hard cooler!

• Keeps contents icy cold for up to 72 hours.
• Includes two cup holders on the top for easy access to your favorite beverages.
• Easy-to-use stretch latches keep the Cooler firmly closed and insulated while on the go.
• A rear drain plug makes clean-up easy and efficient.

 

Product Requirements:

• Due to weight distribution limitations and potential impact on bike handling, the Hard Cooler is recommended for use in the REAR Rack only.
• The Hard Cooler is NOT intended to be used in the Front Rack.

 

Compatibility:

• Lectric XP (XP 1.0, XP 2.0, XP 3.0, & XP4 Models)
  
• Lectric XP Lite (1.0 & 2.0 Models)*
• Lectric XPremium
• Lectric XP Trike (Model 1 & 2)
• Lectric XPedition (1.0 & 2.0 Models)
• Lectric XPeak
• Lectric ONE*
• Lectric XPress*
• Most standard bicycles or eBikes with a rear rack and/or basket

*eBike models with an asterisk do not include a rear rack to mount the Hard Cooler, but can be purchased separately.

 

What's in the Box:

• Hard Cooler (Fully Assembled) 

 

Product Specifications:

• 20 Liter Capacity 
• 45.8cm Length x 35.8cm Width x 34.5cm Height
• Weighs 5.3 kg 
• Outer material: LLDPE, Inner Material: PU Foam 
• Rubber Elastic Front Latches 
• Padded Aluminum Handle 
• 4 Rubber Base-Pads 
• Dual-side Handle Notches
• 10 mm Deep Cup Holders

 

Please note that Lectric have a strict no-return policy on accessories.

 

Hard Cooler Instructions

Hard Cooler Instructions

It's hard to beat an ice-cold beverage at a tailgate, picnic, or get-together on a warm summer day. Keep it cool with the Lectric Hard Cooler!

 

The Lectric Hard Cooler arrives fully assembled so it's ready to use right out of the box! Learn how to use some of the key features below.

Properly Securing the Hard Cooler:

1. Be sure the contents of the cooler do not exceed 20 Liters and the lid is able to close completely.
2. Next, grab one elastic latch and stretch and pull it down until it's able to reach the securing notch.
3. Push the latch end into the notch.
4. Repeat this process for the second latch.
5. Perform a pull test to be sure it is secure. Re-secure or adjust the latches if needed.

Due to weight distribution limitations and potential impact on bike handling, the Hard Cooler is recommended for use in the Rear Rack only. The Hard Cooler is NOT intended to be used in the Front Rack.

 

How to Drain:

1. Locate the plug on the back of the cooler.
2. Unscrew the plug until the seal is broken.
3. Tilt the cooler towards the open plug hole until of contents of the cooler have been drained.
4. Screw the plug back in the drain hole to re-secure. This should get the cooler ready for its next use!

 

If you have any questions, please don't hesitate to contact our support team at [email protected] or 412-567-4390.